Need help?Do you have a question about the NI PXIe-7890 and is the answer not in the manual?
Instructions for safely unpacking the device and inspecting for damage.
Lists the essential components included in the PXIe-7890/7891 kit for setup.
Details the pin assignments for the QSFP connectors (PORT 0 and PORT 1) on the modules.
Details pinouts for the 68-pin VHDCI receptacles (CONNECTOR 0 and 4) for digital I/O.
Details pinouts for Analog Output (AO) connectors (CONNECTOR 1 and 3) on the modules.
Details pinouts for the Analog Input (AI) VHDCI connector (CONNECTOR 2) on the modules.
Explains how to use Measurement & Automation Explorer (MAX) to configure the installed NI hardware.
Steps to diagnose why the PXIe-7890/7891 module is not detected in Measurement & Automation Explorer (MAX).
Procedures to follow if the hardware self-test fails, including calibration and reinstallation.
Troubleshooting steps for an inoperative Analog Output channel on Connector 3 due to shutdown.
Explains residual voltage on an AO channel after an over-temperature shutdown.
Steps to resolve driver power shutdown errors related to excessive consumption or overheating.
Instructions for safely unpacking the device and inspecting for damage.
Lists the essential components included in the PXIe-7890/7891 kit for setup.
Details the pin assignments for the QSFP connectors (PORT 0 and PORT 1) on the modules.
Details pinouts for the 68-pin VHDCI receptacles (CONNECTOR 0 and 4) for digital I/O.
Details pinouts for Analog Output (AO) connectors (CONNECTOR 1 and 3) on the modules.
Details pinouts for the Analog Input (AI) VHDCI connector (CONNECTOR 2) on the modules.
Explains how to use Measurement & Automation Explorer (MAX) to configure the installed NI hardware.
Steps to diagnose why the PXIe-7890/7891 module is not detected in Measurement & Automation Explorer (MAX).
Procedures to follow if the hardware self-test fails, including calibration and reinstallation.
Troubleshooting steps for an inoperative Analog Output channel on Connector 3 due to shutdown.
Explains residual voltage on an AO channel after an over-temperature shutdown.
Steps to resolve driver power shutdown errors related to excessive consumption or overheating.
General| Form Factor | PXI Express |
|---|---|
| Category | I/O Systems |
| Input Voltage Range | ±10 V |
| Output Voltage Range | ±10 V |
| Communication Interface | PXI Express |
| Operating Temperature Range | 0 °C to 55 °C |
| Storage Temperature Range | -40 °C to 70 °C |
| Resolution | 16 bits |
| Digital I/O Voltage | TTL compatible |
| FPGA | Xilinx Kintex-7 |
| Relative Humidity Range | 10 % to 90 % (non-condensing) |
To Next Page
