To Next PageTo Next Page
Need help?Do you have a question about the NI USB-6000 and is the answer not in the manual?
General| Type | Multifunction I/O |
|---|---|
| Analog Input Resolution | 14 bits |
| Analog Output Channels | 2 |
| Analog Output Resolution | 12 bits |
| Analog Output Update Rate | 150 S/s |
| Counter/Timers | 1 |
| Counter/Timer Resolution | 32 bits |
| Counter/Timer Frequency | 5 MHz |
| Interface | USB |
| Power Requirements | USB powered |
| Storage Temperature Range | -20 °C to 70 °C |
| Analog Output Range | 0 V to +5 V |
| Digital I/O Logic Levels | TTL |
| Operating Temperature Range | 0 to 55 °C |
| Relative Humidity Range | 10% to 90% noncondensing |
| Analog Input Sample Rate | 10 kS/s |
Important safety warnings regarding operation, modification, and environment.
Instructions for installing NI-DAQmx and related application software.
Connecting the screw terminal connector plug and USB cable to the device.
Steps to confirm successful device installation using Measurement & Automation Explorer (MAX).
Diagram and table detailing the pinout and descriptions of signals for the NI USB-6000.
Procedure for connecting voltage signals to AI terminals and AI GND for measurement.
Guidance on wiring floating and ground-referenced signals to minimize measurement errors.
Description of digital I/O lines (P0.<0..3>), their configuration, and voltage warnings.
Guidelines to protect the NI USB-6000 from overvoltage, undervoltage, overcurrent, and ESD.
