© National Instruments Corporation 21 SCC Quick Start Guide
Step 7. Launch Measurement & Automation
Explorer (MAX)
Double-click the Measurement & Automation icon on the desktop to
open MAX.
Step 8. Configure the SC-2345/2350
You can use the SC-2350 only in NI-DAQmx 7.2 or later; you can use the
SC-2345 in either NI-DAQmx 7.0 or later.
1. Open Devices and Interfaces. If your device does not automatically
appear, press <F5> to refresh the view in MAX. If the device is still not
recognized, refer to
ni.com/support/install for troubleshooting
information.
2. Right-click Devices and Interfaces and select Create New.
Figure 18. Create New in Devices and Interfaces
3. Select either the SC-2345 or SC-2350 from the Create New window.
To Next Page
Loading...
Need help?
General
