3. Extra Hot Water (Immersion Heater):
Most traditional heating systems have an immersion heater to give you extra hot water quickly. This unit
also has an immersion which should be used sparingly to minimise your electric bill.
4. Regularly Clean The Filter: To ensure the unit runs efficiently you will need to regularly clean
the air filter within the unit (at least every three months). When the screen comes up with the
message FILTER ALARM this is a reminder to clean the filter. You may need to do this more often
in a new house.
The heat pump's air filter needs to be cleaned
regularly (approximately 4 —
interval between cleaning operations varies and
depends on the amount of dust in the exhaust air.
■ Set the switch to “0”.
■
Open the upper front cover by pulling it out by the
lower edge, then lifting it up.
■ Pull out the filter holder.
■ Take out the filter and shake off any dirt.
Check that the filter is not damaged. New original
filters can be ordered from NIBE.
■ Assembly takes place in the reverse order.
The cleaning time intervals vary depending on the
amount of dust in the exhaust air.
A reminder alarm indicates in the display, FILTER
MONITOR when it is time to check the filter.
The building’s ventilation devices should be
cleaned regularly with a small brush to keep the
correct
ventilation. The device settings must not be
changed.
NOTE! If you take down more than one ventilation
device for cleaning, do not mix them up.
Check that the ventilation opening, behind the lower
front cover, is not blocked. Clean if necessary.
Press this button and scroll through your options. The screen will cycle through 24hr,
12hr, 6hr, 3hr and OFF. We suggest you use the 3hr option and once you have hot
water press the button to the
OFF position.
To Next Page
Loading...
