Need help?Do you have a question about the Nibe FIGHTER 310P and is the answer not in the manual?
Section for recording installation details like serial number, date, and installer.
Details how the heat pump extracts energy from ventilation air.
Illustrates the air flow and heat distribution within the house.
Identifies and explains controls like pressure gauge and switch.
Details the functions of the pressure gauge, power switch, and indicator lamps.
Explains the function of the 'Extra hot water' button.
Describes how to adjust the heating curve offset for room temperature.
Details hidden functions like operating mode indications and channel selection.
Identifies controls like indicator lamps, operating mode, and channel selection.
Details how the system regulates indoor temperature based on outdoor conditions.
Guide to setting the basic heating using knobs.
Guidance on adjusting settings for cold and warm weather conditions.
Instructions for temporarily or permanently altering the room temperature.
Instructions for cleaning the heat pump's air filter.
Procedure for cleaning the building's ventilation devices.
Procedure for checking the safety valves.
Explains the function and normal reading of the pressure gauge.
Information on checking extract air temperature.
Guidelines for transporting and storing the heat pump.
Precautions for handling the heat pump, especially the refrigerant.
Details on removing lifting straps.
Instructions on positioning and mounting the heat pump.
Notes on installing the heat pump in hard water areas.
Requirements for inspecting the heating installation before commissioning.
Normal temperature levels in the boiler or water heater.
Covers pipe installation norms, system requirements, and pressure limits.
Notes that the kitchen duct must not be connected.
Instructions for installing the expansion vessel for tap water.
Presents pump performance and pressure drop characteristics.
Specifies ventilation flow requirements and installation area ventilation.
Guidelines for duct installation, earthing, and insulation.
Presents a diagram showing available ventilation capacity.
Details on electrical connections and precautions.
Information on the factory-set output power of the immersion heater.
Procedure for resetting temperature limiters.
Table showing immersion heater output, max current, and breaker.
Details about the immersion heater and its safety limiter.
Instructions for installing the outside sensor.
Details on disconnecting immersion heater steps using load control.
Checks and steps before filling the water heater and heating system.
Procedure for filling the water heater and heating system.
Instructions for venting air from the heat pump and heating system.
Steps to start the heat pump and circulation pump.
Adjusting ventilation flows and fan transformer settings.
Information on readjusting the system after filling and venting.
Procedure for draining the heating water.
Steps to properly empty the water heater.
Procedure for flushing and refilling the hot water and heating systems.
Diagram and explanation for heating curve offset setting.
Diagram and explanation for heating curve offset setting.
Diagram and explanation for heating curve offset setting.
Explains how to use diagrams to set the automatic heating control.
Troubleshooting steps for low hot water temperature or supply.
Troubleshooting steps for insufficient ventilation.
Troubleshooting steps for low room temperature.
Troubleshooting steps for high room temperature.
Explains fault codes and symbols shown on the numerical display.
Indicates the air filter needs cleaning.
Indicates tripped high or low pressure pressostat.
Procedure for resetting tripped pressure switches.
Instructions for resetting miniature circuit breakers (MCBs).
Troubleshooting high extract air temperature.
Procedure to assist the circulation pump in starting.
Instructions for safely opening the front panel for access.
Explains the meaning of different channels on the display.
Safety and regulatory requirements for refrigerant system work.
Instructions on how to change the heat pump's output power.
Labeled diagrams identifying the placement of components.
A comprehensive list of all components with their numbers and functions.
Detailed measurements and spatial requirements for installation.
Illustrates the measuring principle for components.
Comprehensive technical data including dimensions, power, and sound levels.
Performance data according to specific European standards.
To Next Page
General
