Need help?Do you have a question about the Nibe FIGHTER 1220 and is the answer not in the manual?
Provides a general introduction to the NIBE FIGHTER 1220 heat pump.
Explains the heat pump's components and how it produces heat and hot water.
Details the layout, buttons, and display functions of the heat pump's control panel.
Describes how the system automatically manages room temperature and basic settings.
Explains the different operating modes for heating, hot water, and standby.
Covers safe handling, placement, and general installation requirements for the unit.
Details guidelines for collector installation, including depth and length.
Explains the operation of the unit as an electric boiler and the brine pump.
Information on the electric anode's role in protecting the water heater.
Outlines the fundamental requirements for connecting pipes to the heat pump.
Specifics for connecting the collector and heating medium circuits to the unit.
Guidance on connecting the water heater, free cooling, and ventilation recovery modules.
Provides diagrams illustrating pump performance for heating and brine circuits.
Instructions for the primary electrical hook-up and resetting the temperature limiter.
Details on wiring for tariff control and managing separate electrical supplies.
Procedures for adjusting maximum hot water temperature and phase current limits.
Information on connecting for centralised load control, monitoring, and external inputs.
Instructions for connecting the outdoor temperature sensor and understanding alarm outputs.
Steps before startup, including filling collector and heating medium systems.
Procedures for initial system startup, inspection, and fine-tuning parameters.
Guidance on using diagrams to set heating curves and offsets for optimal control.
Explains menu structure, navigation, parameter changes, and display symbols.
Configuration of clock settings, language, display, and operating modes.
Detailed settings for controlling hot water temperature and heating flow temperatures.
Configuration of outdoor temperature display and brine circuit parameters.
Accessing and using service menus for advanced settings, additional heat, and operating modes.
Explains common alarm messages and their potential causes for the heat pump.
Provides causes and solutions for problems like no hot water or low room temperature.
Procedures for helping circulation pumps start and safely draining system components.
Provides physical dimensions and setting-out coordinates for unit installation.
A detailed list of components and visual guides for their placement within the unit.
Comprehensive wiring schematics and electrical circuit diagrams for the unit.
Key technical data, performance figures, and a list of included kit components.
Information on available accessories that can be added to the FIGHTER 1220 system.
To Next Page
General
