Control
For the Installer
22
FIGHTER 1220
The menu tree shows all the menus. Three different
menu types can be chosen.
Normal, covers the normal user's needs.
Extended, shows all menus except the service
menus.
Service, shows all menus, returns to Normal 30
minutes after the last button was pressed.
Changing of menu type is done from menu 8.1.1
Example
■ The starting point is menu 1.0.
■ Press the minus button to move to menu 8.0.
■ Press the enter button to move to menu 8.1.0.
■ Press the enter button to move to menu 8.1.1.
■ Press the enter button to allow the value to be
changed.
■ Change the value by pressing the plus or minus
buttons.
■
Confirm the chosen value by pressing the enter but-
ton.
■
Press the operating mode button followed by enter
(quick movement) to return to menu 1.0.
Information is presented on the display about the status
of the heat pump and the electric boiler. Menu 1.0 is nor-
mally shown on the display. The Plus and Minus buttons
and the Enter button are used to scroll through the menu
system as well as to change the set value in some
menus.
The Plus button is used to move for-
ward to the next menu on the current
menu level and to increase the value of
the parameter in menus where this is
possible.
The Minus button is used to move back
to the previous menu on the current
menu level and to decrease value of
the parameter in menus where this is
possible.
The Enter button is used to select sub-
menus of the current menu, to permit
parameters to be changed and confirm
any changes to parameters. When the
menu number ends with a zero this
indicates there is a submenu.
N
U
S
General
Menu number Menu nameKey lock
Clock
Symbols
Value of the
current
parameter
To Next Page
Loading...
