Need help?Do you have a question about the Nibe Fighter 200P and is the answer not in the manual?
Explains how the heat pump recovers energy from ventilation air to heat water and the house.
Illustrates the flow of air and heat within the system and the house.
Instructions for regular cleaning of the heat pump's air filter.
Guidance on cleaning the building's ventilation devices for proper airflow.
Explains how to read and interpret the pressure gauge.
Procedure for regularly checking the unit's safety valves.
Lists potential causes and checks for insufficient hot water supply.
Identifies issues related to insufficient ventilation and possible causes.
Troubleshooting steps for when the room temperature is too low.
Addresses potential causes for excessively high room temperatures.
Explains the function and implications of setting the switch to position "3".
Advises on when and how to clean the fan, often requiring professional help.
Explains the meaning of various indicator lamps and display signals.
Step-by-step guide to resetting tripped pressostats.
Instructions for troubleshooting and starting the circulation pump.
Guidelines for safely transporting and storing the heat pump.
Precautions for handling the unit, especially regarding refrigerant.
Detailed instructions and considerations for installing the heat pump.
Advice on installing the unit in areas with hard water.
Requirements for inspection before commissioning the heating installation.
Information on the maximum system volumes the unit can support.
General requirements and norms for pipe installation.
Diagram showing available pressure versus flow rate for the pump.
Instructions for connecting the hot and cold water supply.
Specifies the required ventilation flow rates and options.
Guidelines for installing ventilation ducts, including earthing and insulation.
Specific instruction that the kitchen duct must not be connected to the unit.
How to adjust ventilation for optimal performance and efficiency.
Graph showing available ventilation capacity based on airflow.
Instructions for connecting the main power supply to the unit.
How to adjust fan speed using control board knobs.
Guidance on connecting a switch for normal/reduced ventilation.
How the circulation pump is controlled by room thermostats or manually.
Information on the required fuse rating for the unit.
Details about the immersion heater and its safety features.
Instructions for connecting the optional clock thermostat.
Pre-commissioning checks and settings required before starting.
Step-by-step guide to filling the system with water.
Procedure for removing air from the heating system.
Instructions for starting the heat pump after commissioning.
How to set the ventilation system for optimal operation.
Guidance on re-venting the system if needed after initial operation.
Procedure for draining the heating system.
Instructions on how to drain the water heater.
Detailed guide on using the included clock thermostat.
Information on compressor cut-in and cut-out temperatures.
Explanation of the function for periodic temperature boosts.
How the system protects against freezing and prioritizes hot water.
Instructions for accessing the unit's internal distribution box.
Safety and procedural information for working with the refrigerant system.
Provides physical dimensions and installation spacing requirements.
Illustrates principles for pipe sizing and connections.
Details on the separately delivered tap water expansion vessel.
Information about the included clock thermostat.
Information about the separately delivered bracket.
Information about the included earth cable.
Lists optional accessories like heightening consoles and top cabinets.
To Next Page
General
