Nibe Fighter 200P - Maintenance Routines; Cleaning the Air Filter

Maintenance routines
5
For Home Owners
FIGHTER 200P
The heat pump air filter (63) should be cleaned regu-
larly, about four times a year.
■ Set the switch (8) to “0”.
■ The upper service cover is opened by pulling the
lower section outwards. The cover can then be lif-
ted off.
■ Pull out the filter cassette (78).
■ Take out the filter and shake off any dirt. (When
the filter is very dirty, turn it upside-down and wash
it carefully with water.)
Check that the filter is not damaged. New original
filters can be ordered from NIBE.
■ Re-assembly takes place in the reverse order.
The cleaning time intervals vary depending on the
amount of dust in the exhaust air. Each third month
an indicator lamp “Midmost lamp” flashing to reminds
about cleaning the air filter. Note that the time will be
set to zero by setting the switch to "0".
LEK
The heat pump and its ventilation ducting require some
regular maintenance when the following points should
be checked.
The numbers in brackets refer to the section ”Compo-
nent locations”.
Cleaning the air filter
Art.nr. 611830
( )
( )
( )
20 100
40 80
60
°C
0 120
T G
2
1
bar
3
04
T G
Art.nr. 611830
20 100
40 80
60
°C
0 120
T G
2
1
bar
3
04
T G
Art.nr. 611830
20 100
40 80
60
°C
0 120
T G
2
1
bar
3
04
T G