Nibe FIGHTER 310P - Maintenance routines; Cleaning the air filter

Front panel
7
FIGHTER 310P
For Home Owners
Channel selection
Use the “Channel selection” button to browse
forward through the display window channels to
see the required reading or setting.
Available readings/settings include:
1 Boiler temperature
2 Flow temperature
3 Outdoor temperature
5 Extract air temperature
Normally the display always shows Channel 1.
When you have browsed through the channels,
channel 1 returns after a while.
Heating curve selection
Use the “Heating curve selection” knob to set
the automatic heating control system; see sec-
tion “Room temperature”.
I
J
Hidden functions
The two lamps next to the operating mode selec-
tor indicate the chosen operating mode. This
should not be confused with the indicating lamps
in the numerical display.
Uppermost lamp “Immersion heater”
Lit The immersion heater may be con-
nected if necessary, i.e. when the
compressor cannot single handed
cover the heating requirement.
Not lit The immersion heater is disabled.
Bottom lamp “Circulation pump”
Lit The circulation pump is
operational.
Not lit The circulation pump is not opera-
tional, however it is automatically
exercised twice a day. The shunt is
valve is also closed in this position.
Operating mode indications
G
Art.nr. 611822
2
1
bar
3
04
2
1
bar
3
04
2
1
bar
3
04
Transparent, blåfärgad film (ej hål).
67,5
57.25
26,3
86,3
92,7
126,8
129,8
132,8
145,2
336
41
19,2
83
90.5
111
98,6
523
10,5
Ø 52,8
53,5
135,3
130,7
15
70,5
135,3
r=4,5
37
23
9
2 st Ø 4,5, transparent, ofärgad film (ej hål).
OBS! Endast halv cirkel (radie=11)
Slits på baksidan
De 8 grårastrerade ytorna (Ø22)
skall ej förses med häftämne.
49,5
84,4
85,7
186,3
196,8
42,5
52
161
Ø 13
Ø 18,5
Hål 16 x 31
Hål 16 x 16
313,2
Operating mode
When the heat pump is started, all functions
(immersion heater, circulation pump and auto-
matic heating control system) are running.
Pressing the “Operating mode” button once dis-
ables the immersion heater.
Pressing it once more stops the circulation
pump as well. Only hot water production is then
obtained.
Pressing it yet again reconnects the immersion
heater and the circulation pump.
H
Miniature circuit-breaker
Resetting the miniature circuit
breakers.
K
Temperature limiter
Resetting the temperature limiter.
L
Art.nr. 611822
2
1
bar
3
04
2
1
bar
3
04
2
1
bar
3
04
Transparent, blåfärgad film (ej hål).
67,5
57.25
26,3
86,3
92,7
126,8
129,8
132,8
145,2
336
41
19,2
83
90.5
111
98,6
523
10,5
Ø 52,8
53,5
135,3
130,7
15
70,5
135,3
r=4,5
37
23
9
2 st Ø 4,5, transparent, ofärgad film (ej hål).
OBS! Endast halv cirkel (radie=11)
Slits på baksidan
De 8 grårastrerade ytorna (Ø22)
skall ej förses med häftämne.
49,5
84,4
85,7
186,3
196,8
42,5
52
161
Ø 13
Ø 18,5
Hål 16 x 31
Hål 16 x 16
313,2
Art.nr. 611822
2
1
bar
3
04
2
1
bar
3
04
2
1
bar
3
04
Transparent, blåfärgad film (ej hål).
67,5
57.25
26,3
86,3
92,7
126,8
129,8
132,8
145,2
336
41
19,2
83
90.5
111
98,6
523
10,5
Ø 52,8
53,5
135,3
130,7
15
70,5
135,3
r=4,5
37
23
9
2 st Ø 4,5, transparent, ofärgad film (ej hål).
OBS! Endast halv cirkel (radie=11)
Slits på baksidan
De 8 grårastrerade ytorna (Ø22)
skall ej förses med häftämne.
49,5
84,4
85,7
186,3
196,8
42,5
52
161
Ø 13
Ø 18,5
Hål 16 x 31
Hål 16 x 16
313,2
Fan speed
This switch is used for changing the fan
speed.
It is possible to switch between three different
speeds:
Position A: Reduced ventilation
Position B: Normal ventilation
Position C: Forced ventilation
Position B is normally used.
Position A is used on occasions when a lower
ventilation flow is acceptable in the house, for
example, when no one is in the house. This
position should not be used over long periods.
Otherwise there is a risk of an inferior indoor cli-
mate as well as damage due to dampness in
the house.
Position C is used on occasions when a higher
ventilation flow is sought in the house, for exam-
ple, when there are many people in the house.
This position should not be used over long peri-
ods. Otherwise this will increase energy con-
sumption and with that operating costs.
M
Art.nr. 611603
2
1
bar
3
04
2
1
bar
3
04
2
1
bar
3
04
Tr ansparent, blåfärgad film (ej hål).
18,6
98,1
26,3
4,2
86,3
92,7
126,8
129,8
132,8
145,2
272,5
336
41
19,2
83
90.5
111
98,6
523
10,5
Ø 52,8
53,5
135,3
130,7
15
70,5
135,3
261,5
r=4,5
37
23
9
2 st Ø 4,5, transparent, ofärgad film (ej hål).
OBS! Endast halv cirkel (radie=11)
Slits på baksidan
De 8 grårastrerade ytorna (Ø22)
skall ej förses med häftämne.
49,5
84,4
85,7
186,3
196,8
42,5
67,5
57,25
52
161
Ø 13
Ø 18,5
Ø 62
Hål 16 x 31
Hål 16 x 16
313,2
2 st urstansninga , bredd=5 och r=2,5