Nibe AMS 10-8 - Commissioning and Adjusting; 6 Commissioning and Adjusting Compressor Heater

Compressor heater
AMS 10 is equipped with a compressor heater (CH) that
heats the compressor before start-up and when the
compressor is cold. (Does not apply to AMS 10-6.)
NOTE
The compressor heater must have been con-
nected for 6 – 8 hours before the first start,
see the section “Start-up and inspection” in
the Installer Manual for the indoor module or
control module.
NOTE
For information: See chapter “Commissioning
and adjustment” in the Installer Manual for
HBS 05.
31Chapter 6 | Commissioning and adjustingNIBE AMS 10
6 Commissioning and adjusting