17.
Reconnect the cables T26 (red) and T27 (blue), see
the designations.
18.
Press the white cable mount onto the board.
Install the rest of the cables.
w
19.
Use the cable mounts to get the cables tidy and to
keep them in place.
20.
The three screws that were securing the reactor
should be reused to install the new mounting plate.
21.
Hook the new reactor into place in the cut-out in the
mounting plate.
22.
Secure the reactor with the two enclosed screws
in the mounting plate.
15| GB
To Next Page
Loading...
