Nibe CDS 10 - Connection; Pairing Wireless Accessory; LED Status Indications; Network Connection

Connection
Pairing is performed in the heat pump’s/control module’s
display, select menu 5.4 – Wireless units. CDS 10 should be
paired before it is installed on the wall.
Settings for control are made in menu 1.3.3 - Room sensor
settings.
PAIR YOUR WIRELESS ACCESSORY WITH YOUR
MAIN PRODUCT
Wireless accessory
Main product
MENU 5.4 – CONNECT WIRELESS UNITS
WIRELESS UNITS
Room sensor
CDS10
Add unit
Here, you connect your wireless units. Press "Add unit" and
follow the guide that is launched. You can also check the
connected units’ battery level and signal strength.
CONNECT TO NETWORK
If CDS 10 is flashing red (once every five seconds), it is
searching for a wireless network to connect to. If no network
is found, searching stops after 5 minutes. You can start a
new search by pressing and holding the (SF1) button on
CDS 10 for 3 seconds.
If you need to test the range of the signal, CDS 10 can be
connected to the heat pump at close range and then moved
further away. Wait for at least 30 minutes. The signal
strength can then be read off in the heat pump’s/control
module’s menu system (menu 5.4).
To leave a network and reset CDS 10, press and hold the
(SF1) button for 10 seconds and wait until the red LED comes
on for 5 seconds.
SF1
LED INDICATIONS
ExplanationLED
Factory resetRed LED comes on for five
seconds
Connecting to networkRed LED flashes once every
five seconds
Low batteryRed LED flashes twice
within five seconds
Lost connection or unit is not connec-
ted to network
Red LED flashes three
times within five seconds
Identification modeGreen LED flashes
REPEATER RPP 10
If the signal strength between the main product and the
accessory in a zone is low, you may need to install a repeater
to amplify the signal between the zones.
1 2
3
1 2
3
Main product Repeater
CDS 10 | EN14