Nibe F1255 - Setting the Indoor Climate

3
F1255 – at your service
Set the indoor climate
Overview
Sub-menus
WHPSHUDWXUH
,1'225 &/,0$7( 
YHQWLODWLRQ
VFKHGXOLQJ
DGYDQFHG
RII
QRUPDO
For the menu INDOOR CLIMATE
there are several sub-menus. Status
information for the relevant menu can
be found on the display to the right
of the menus.
temperature Setting the temperature
for the climate system. The status in-
formation shows the set values for the
climate system.
ventilation Setting the fan speed. The
status information shows the selected
setting. This menu is only displayed if the exhaust air module is connected
(accessory).
scheduling Scheduling heating, cooling and ventilation. Status information
"set" is displayed if you set a schedule but it is not active now, "holiday
setting" is displayed if the vacation schedule is active at the same time as
the schedule (the vacation function is prioritised), "active" displays if any
part of the schedule is active, otherwise it displays " off".
advanced Setting of heat curve, adjusting with external contact, minimum
value for supply temperature, room sensor and cooling function.
temperature
WHPSHUDWXUH 
If the house has several climate sys-
tems, this is indicated on the display
by a thermometer for each system.
If the heat pump has an accessory for
cooling or integrated cooling function
this is shown in the display with an
extra tab.
Set the temperature (with room
sensors installed and activated):
Setting range: 5 - 30 °C
Default value: 20
Menu
1.1
NIBE™ F1255Chapter 3 | F1255 – at your service24