12
F205P
For the Installer
Put the connected thermostat onto the back panel in the
wall, then fix it with the two screws in the packing box.
Put the cover with 30 degree angle, then fix the up two
clips;
Push the places of the two down clips, fix the cover, and
finish the installation.
Open the main control panel. Put the screwdriver
(3.5mm) into the block 4mm along the bevel. Prize up,
open the clips.
Take off the wires.
As per wiring diagram, connect it with terminals, fixed by
the screwdriver.
Be sure to connect all the wires as per the
wiring diagrams and keep it away from
water, mud and other material so as to
prevent the unit being spoiled!
Note!
Installing the clock thermostat
Installing the clock thermostat
To Next Page
Loading...
