Nibe F730 - Page 36

Day: Select which day or days of the week the scheduling is to apply to here.
To remove the scheduling for a particular day, the time for that day must be reset
by setting the start time to the same as the stop time. If the row "all" is used, all
days in the period are set according to that row.
Time period: The start and stop time for the selected day for scheduling are se-
lected here.
Adjustment: How much the heating curve is to be offset in relation to menu 1.1
during scheduling is set here. If a room sensor is installed, the desired room
temperature is set in °C.
Conflict: If two settings conflict with each other, a red exclamation mark is dis-
played.
TIP
If you wish to set similar scheduling for every day of the week start
by filling in “all” and then changing the desired days.
TIP
Set the stop time earlier than the start time so that the period extends
beyond midnight. Scheduling then stops at the set stop time the day
after.
Scheduling always starts on the date that the start time is set for.
Caution
Changes of temperature in accommodation take time. For example,
short time periods in combination with underfloor heating will not give
a noticeable difference in room temperature.
If the exhaust air temperature falls below 6 °C the compressor is
blocked and electric additional heat is permitted. When the compressor
is blocked heat is not recovered from the exhaust air.
VENTILATION
Increases or decreases in the ventilation to the accommodation can be scheduled
here for up to two time periods per day.
Menu
1.3.3
NIBE F730Chapter 3 | F730 – at your service36