POINT OFFSET
point offset 1.9.8
change in curve
outdoor temp. point
°C
°C
outdoor temp. °C
flow temperature °C
outdoor temp. point
Setting range: -40 – 30 °C
Default value: 0 °C
change in curve
Setting range: -10 – 10 °C
Default value: 0 °C
Menu
1.9.8
Select a change in the heating curve at a certain outdoor temperature here. One
step is usually enough to change the room temperature by one degree, but in
some cases several steps may be required.
The heat curve is affected at ± 5 °C from set outdoor temp. point.
It is important that the correct heating curve is selected so that the room tem-
perature is experienced as even.
TIP
If it is cold in the house, at, for example -2 °C, "outdoor temp. point"
is set to "-2" and "change in curve" is increased until the desired room
temperature is maintained.
Caution
Wait 24 hours before making a new setting, so that the room temper-
ature has time to stabilise.
NIBE F730Chapter 3 | F730 – at your service46
To Next Page
Loading...
