ALARM LOG
alarm log 3.4
TB alarm
LP alarm
Sensor flt:BT6
Sens flt:BT20
Sensor flt:BT2
Sensor flt:BT1
To facilitate fault-finding the heat pump
operating status at alarm alerts is stored
here. You can see information for the 10
most recent alarms.
To view the run status in the event of an
alarm, mark the alarm and press the OK
button.
alarm log 3.4
outdoor temp.
heat medium flow
heat medium return
hot water charging
condenser out
operating time
op. mode
Temperature limiter alarm(52)
-5.6 °C
30.5 °C
25.0 °C
49.0 °C
30 min
off
6.2 °C
Information about an alarm.
Menu
3.4
INDOOR TEMP. LOG
week
exhaust air °C
indoor temp. log3.5
Here you can see the average temperature
indoors week by week during the past
year. The dotted line indicates the annual
average temperature.
To read off an average
temperature
1.
Turn the control knob so that the ring
on the shaft with the week number is
marked.
2.
Press the OK button.
3.
Follow the grey line up to the graph and out to the left to read off the average
indoor temperature at the selected week.
4.
You can now select to take read outs for different weeks by turning the
control knob to the right or left and read off the average temperature.
5.
Press the OK or Back button to exit read off mode.
Menu
3.5
55Chapter 3 | F730 – at your serviceNIBE F730
To Next Page
Loading...
