Nibe F730 - Page 60

NOTE
Telephone numbers provided must be able to receive SMS messages.
SG READY
affect room temperature
affect hot water
SG Ready 4.1.5
This function can only be used in mains
networks that support the "SG
Ready"-standard .
Make settings for the function "SG Ready"
here.
affect room temperature
Here you set whether room temperature
should be affected when activating "SG
Ready".
Menu
4.1.5
With low price mode on "SG Ready" the parallel offset for the indoor temperature
is increased by "+1". If a room sensor is installed and activated, the desired room
temperature is instead increased by 1 °C.
With over capacity mode on "SG Ready" the parallel offset for the indoor temper-
ature is increased by "+2". If a room sensor is installed and activated, the desired
room temperature is instead increased by 2 °C.
affect hot water
Here you set whether the temperature of the hot water should be affected when
activating "SG Ready".
With low price mode on "SG Ready" the stop temperature of the hot water is
set as high as possible at only compressor operation (immersion heater not
permitted).
With over capacity mode of "SG Ready" the hot water is set to "luxury" (immersion
heater permitted).
NOTE
The function must be connected and activated in your F730.
NIBE F730Chapter 3 | F730 – at your service60