Nibe F730 - Page 68

OP. PRIORITISATION
min
min
hot water
heating
op. prioritisation 4.9.1
op. prioritisation
Setting range: 0 to 180 min
Default value: 30 min
Choose here how long the heat pump should work with each requirement if
there are two requirements at the same time. If there is only one requirement
the heat pump only works with that requirement.
The indicator marks where in the cycle the heat pump is.
If 0 minutes is selected it means that requirement is not prioritised, but will only
be activated when there is no other requirement.
Menu
4.9.1
AUTO MODE SETTING
stop heating
stop additional heat
filtering time
°C
°C
hrs
auto mode setting4.9.2
stop heating
Setting range: -20 – 40 °C
Default values: 17
stop additional heat
Setting range: -25 – 40 °C
Factory setting: 10
filtering time
Setting range: 0 – 48 h
Default value: 24 h
Menu
4.9.2
When the operating mode is set to "auto", the heat pump selects when start and
stop of additional heat and heat production is permitted, dependent on the aver-
age outdoor temperature.
Select the average outdoor temperatures in this menu.
NIBE F730Chapter 3 | F730 – at your service68