reset by setting the start time to the same as the stop time. If the line "all"
is used, all days in the period are set for these times.
Time period: The start and stop time for the selected day for scheduling are
selected here.
Adjusting: The desired fan speed is set here.
TIP
If you wish to set similar scheduling for every day of the week start by filling
in “all” and then changing the desired days.
Caution
If the stop time is before the start time it means that the period extends past
midnight. Scheduling always starts on the date that the start time is set for.
A significant change over a longer period of time may cause poor indoor
environment and worse operating economy.
advanced
DGYDQFHG
KHDWLQJ FXUYH
H[WHUQDO DGMXVWPHQW
PLQ IORZ OLQH WHPS
URRP VHQVRU VHWWLQJV
IDQ UHWXUQ WLPH
RZQ FXUYH
Menu
1.9
Menu advanced has orange text and is intended for the advanced user. This
menu has several sub-menus.
heating curve Setting the heating curve slope.
external adjustment Setting the heat curve offset when the external contact
is connected.
min. flow line temp. Setting minimum permitted flow line temperature.
37NIBE™ F750Chapter 3 | F750 – at your service
To Next Page
Loading...
Need help?
General
