USB SERVICE OUTLET
When a USB memory is connected, a new menu (menu 8)
appears in the display.
Menu 8.1 - "Update the software"
You can update the software with a USB memory in menu
8.1 - "Update the software".
NOTE
In order to update using a USB memory, the
memory must contain a file with software for S1156
from NIBE.
Software for S1156 can be downloaded from
https://myuplink.com.
One or more files are shown in the display. Select a file and
press "OK".
TIP
A software update does not reset the menu set-
tings in S1156.
Caution
If the update is interrupted before it is complete
(e.g. during a power cut), the software is automat-
ically restored to the previous version.
Menu 8.2 - Logging
Interval
Setting range: 1 s – 60 min
Here you can choose how current measurement values from
S1156 should be saved onto a log file on the USB memory.
1. Set the desired interval between loggings.
2. Select “Start logging".
3. The relevant measurement values from S1156 are now
saved in a file on the USB memory at the set interval
until you select "Stop logging".
Caution
Select "Stop logging" before removing the USB
memory.
Logging floor drying
Here you can save a floor drying log on the USB memory
and in this way see when the concrete slab reached the
correct temperature.
• Make sure that "Underfloor drying function" is activated
in menu 7.5.2.
• A log file is now created, where the temperature and the
immersion heater output can be read off. Logging contin-
ues until "Underfloor drying function" is stopped.
Caution
Close "Underfloor drying function" before removing
the USB memory.
Menu 8.3 - Manage settings
Save settings
Alternative: on/off
Display backup
Alternative: on/off
Restore settings
Alternative: on/off
In this menu, you save/upload menu settings to/from a USB
memory stick.
Save settings: Here, you save menu settings in order to re-
store them later or to copy the settings to another S1156.
Display backup: Here, you save both menu settings and
measurement values, e.g. energy data.
Caution
When you save menu settings to the USB memory,
you replace any previously saved settings on the
USB memory.
Restore settings: Here, you upload all menu settings from
the USB memory stick.
Caution
Resetting of menu settings from the USB memory
cannot be undone.
Manual restoring of software
If you want to restore the software to the previous version:
1. Switch off S1156 via the shutdown menu. The status
lamp goes out, off/on button light up blue.
2. Press the on/off button once.
NIBE S1156Chapter 10 | Service66
To Next Page
Loading...
