Nibe S1255 - Menu 7 - Installer Settings

Menu 7 - Installer settings
OVERVIEW
7.1.1.1 - Temperature setting7.1.1 - Hot water7.1 - Operating settings
1
7.1.1.2 - Operating settings
7.1.2.1 - Op. mode HM pump GP1
1
7.1.2 - Circulation pumps
7.1.2.2 - Pp sp. heating medium GP1
1
7.1.2.6 - Operating mode brine pump
1
7.1.2.7 - Pump speed brine
1
7.1.2.8 - Brine alarm setting
7.1.3.1 - BlockFreq7.1.3 - Compressor
7.1.4.1 - Fan speed, exhaust air
2
7.1.4 - Ventilation
2
7.1.4.2 - Fan speed, supply air
2
7.1.4.3 - Fine-tuning the ventilation
2
7.1.5.1 - Int elec add heat7.1.5 - Add. heat
7.1.6.1 - Max diff supply temp7.1.6 - Heating
7.1.6.2 - Flow settings, climate sys
7.1.6.3 - Power at DOT
7.1.8.1 - Alarm actions7.1.8 - Alarms
7.1.8.2 - Emergency mode
7.1.9 - Load monitor
7.1.10.1 - Operating prioritisation7.1.10 - System settings
7.1.10.2 - Auto mode setting
7.1.10.3 - Degree minute settings
7.2.1 - Add/remove accessories7.2 - Accessory settings
2
7.2.19 - external energy meter
7.2.25 - PVT Source (PVT)
7.3.1 - Configure7.3 - Multi-installation
7.3.2 - Installed heat pumps
7.3.3 - Name heat pump
7.3.4 - docking
7.4 - Selectable in/outputs
7.5.1 - Heat pump, test7.5 - Tools
7.5.1.1 - Test mode
7.5.2 - Underfloor drying function
7.5.3 - forced control
7.5.6 - Inverter replacement
7.5.8 - Screen lock
7.5.9 - Modbus TCP/IP
7.6 - factory setting service
7.7 - start guide
7.8 - quick start
7.9.1 - Change log7.9 - Logs
7.9.2 - Extended alarm log
7.9.3 - Black box
1
This menu is also shown in any installed subordinate heat pump’s limited menu system.
2
Consult the accessory’s Installer Manual.
MENU 7.1 - OPERATING SETTINGS
Make operating settings for the system here.
MENU 7.1.1 - HOT WATER
This menu contains advanced settings for hot water opera-
tion.
49Chapter 9 | Control - MenusNIBE S1255