Nibe S1255 - Item Register

A
Accessories, 64
Alarm, 62
Assembly, 6
B
Brine side, 15
C
Climate system, 16
Climate systems and zones, 37
Control - Introduction, 37
Cold and hot water, 16
Connecting cold and hot water, 16
Commissioning and adjusting, 28
Filling and venting, 28
Post adjustment and bleeding, 29
Preparations, 28
Start guide, 29
Connecting accessories, 22
Connecting current sensors, 22
Connecting external operating voltage for the control sys-
tem, 20
Connecting hot water circulation, 17
Connecting sensors, 21
Connecting the climate system, 16
Connections, 20
Control, 34
Control - Introduction, 34
Control - Introduction, 34
Control - Menus
Menu 1 - Indoor climate, 38
Menu 2 - Hot water, 41
Menu 3 - Info, 43
Menu 4 - My system, 44
Menu 5 - Connection, 47
Menu 6 - Scheduling, 48
Menu 7 - Service, 49
Cooling section, 11
D
Data for energy efficiency of the system, 75
Delivery and handling, 6
Assembly, 6
Drawing out the cooling module, 6
Installation area, 6
Removing parts of the insulation, 9
Removing the covers, 7
Supplied components, 7
Transport, 6
Diagram, dimensioning compressor speed, 70
Dimensions and pipe connections, 14
Dimensions and setting-out coordinates, 66
Disruption to comfort
Info menu, 62
Disturbances in comfort, 62
Alarm, 62
Manage alarm, 62
Troubleshooting, 62
Docking alternatives
Free cooling, 17
Ground water system, 16
Pool, 17
Two or more climate systems, 17
Ventilation recovery, 17
Draining the climate system, 57
Draining the hot water heater, 57
Drawing out the cooling module, 6, 59
E
Electrical addition - maximum output, 25
Power steps of the immersion heater, 25
Switching to maximum electrical output, 26
Electrical cabinets, 11
Electrical connection, 18
General, 18
Electrical connections
Connecting accessories, 22
Connecting external operating voltage for the control
system, 20
Connecting sensors, 21
Connections, 20
Electrical addition - maximum output, 25
External connection options, 23
External connections, 21
External energy meter, 21
Load monitor, 22
Multi-installation, 22
Outdoor sensor, 21
Power connection, 20
Room sensor, 21
Settings, 25
Tariff control, 20
Temperature sensor, external flow line, 21
Emptying the brine system, 58
Energy labelling, 73
Data for energy efficiency of the package, 75
Information sheet, 73–74
Technical documentation, 76, 78, 80
External connection options, 23
Possible selection for AUX inputs, 24
Possible selection for AUX output (potential free variable
relay), 25
External connections, 21
External energy meter, 21
F
Filling and venting, 28
Filling and venting the brine system, 28
Filling and venting the climate system, 28
Filling the hot water heater, 28
Filling and venting the brine system, 28
Filling and venting the climate system, 28
Filling the hot water heater, 28
H
Helping the circulation pump to start, 59
Help menu, 35
I
Important information, 4
Marking, 4
Info menu, 62
Information sheet, 73
Inspection of the installation, 5
Installation alternative
Connecting hot water circulation, 17
Water heater with immersion heater, 16
Installation area, 6
NIBE S1255Item register84
Item register