Nibe SMO 20 - Network Connectivity; NIBE Uplink Setup; TCP;IP Settings

NIBE Uplink
request new connection string
serial number
nibe uplink 4.1.3.1
switch off all users
connection string
number of users
Here you can manage the installa-
tion's connection to NIBE NIBE Uplink
(www.nibeuplink.com) and see the
number of users connected to the in-
stallation via the internet.
A connected user has a user account
in NIBE NIBE Uplink, which has been
given permission to control and/or
monitor your installation.
Request new connection string
To connect a user account on NIBE NIBE UplinkmyUpway to your installa-
tion, you must request a unique connection code.
Menu
4.1.3.1
1.
Mark “request new connection string" and press the OK button.
2.
The installation now communicates with NIBE NIBE UplinkmyUpway
to create a connection code.
3.
When a connection string has been received, it is shown in this menu
at "connection string" and is valid for 60 minutes.
Disconnect all users
1.
Mark “switch off all users" and press the OK button.
2.
The installation now communicates with NIBE NIBE Uplink to release
your installation from all users connected via the internet.
NOTE
After disconnecting all users, none of them can monitor or control your
installation via NIBE NIBE Uplink without requesting a new connection
code.
tcp/ip settings
tcp/ip settings4.1.3.8
confirm reset
automatic
ip-address
net mask
gateway
dns
You can set TCP/IP settings for your
installation here.
Automatic setting (DHCP)
Menu
4.1.3.8
1.
Tick “automatic". The installation
now receives the TCP/IP settings
using DHCP.
2.
Mark “confirm" and press the OK
button.
49NIBE™ SMO 20Chapter 3 | SMO 20 – at your service