17VEDEX 4000
Charge and circulation pump
If a charge or circulation pump is not in operation for
an extended period of time, it should be started from
time to time so that it does not jam.
Ash can still contain glowing embers after
a long period of time. Therefore, always use
a non-inammable container when emptying
ash and soot.
NOTE
Cleaning the combustion chamber.
The bottom section of the cleaning chamber is
cleaned via the door in the boiler’s bottom section. In
order to clean the combustion chamber properly:
1. Open the combustion chamber door.
2. Remove the vermiculite plate (see picture bellow).
3. Remove turbulators below ash tray.
4. Remove the tray.
5. Empty the tray, remove ash and ash residue. Clean
thoroughly.
6. Clean the chamber.
7. Replace the ash drawer and close the door.
8. The combustion chamber was cleaned properly
and is ready for operation.
Cleaning the convection section
The convection section needs to be cleaned a few
times in between chimney-sweep visits. In order to
clean convection channels properly:
• Remove convection channel cover from the boil-
er top section.
• Remove turbulators from the convection section.
• Clean the convection section using round brush,
attached with the kit.
• Mount turbulators, as per the sequence shown on
page 20.
• Mount the cover of boiler’s convection channels
LEK
1
2
To Next Page
Loading...
