Need help?Do you have a question about the Nibe EVC 13 and is the answer not in the manual?
Explains using a map to determine initial heating curve and offset settings based on system type.
Describes how to read and use heating curve diagrams to set the boiler's response to outdoor temperatures.
Explains accessing and setting the max thermostat for limiting boiler/supply line temperature.
Details the operation, testing, and maintenance of the safety valve.
Lists potential causes and solutions for low room temperature issues.
Explains the use and function of the emergency mode on the operating switch.
Outlines common reasons for a lack of hot water when using the EVC 13 with an electric water heater.
Details how to reset the temperature limiter if it has tripped.
Provides troubleshooting steps for scenarios where the room temperature is too high.
Provides guidelines for safely transporting and installing the EVC 13 boiler, including clearance requirements.
Explains the specifications and function of the expansion vessel in the heating system.
Provides step-by-step instructions and safety precautions for draining the boiler water.
Details electrical connection requirements, including circuit breakers, wiring, and supplier permissions.
Explains the function of the max thermostat and temperature limitation potentiometers for controlling supply temperature.
Explains the different modes (0, 1, 2, 3) of the operating switch.
Details how the immersion heater power is controlled and restricted, including setting limits.
Guides through the process of filling the heating system with water and checking pressure.
Explains how to vent air from the boiler and the heating system.
Covers post-venting pressure adjustment and setting the automatic heating control system.
Presents detailed physical dimensions and layout information for installation.
To Next Page
General
