Nice FLOX2R User Manual

This operation will also let you add the code number of a new transmitter to the receiver’s memory.
1) Press the key on the receiver and hold it down: the LED turns on and you must then.
2) Transmit the code number until the LED turns off pressing any key on the transmitter.
3) Now release the transmitter key: the LED will turn back on ready for a new operation.
4) Repeat the procedure from point 2 for the other transmitters.
Entering a code number (normal way)
This operation too will let you add the code number of a new transmitter to the receiver’s memory.
1) Press the key on the receiver for a moment: the LED will turn on for 5 seconds. Within this time you must:
2) Transmit the code number until the LED turns off pressing any key on the transmitter.
3) Release the transmitter key and wait a second.
4) Transmit the code to confirm by pressing any key on the transmitter.
The LED will now flash 3 times meaning that the operation was done properly; if this does not
happen, repeat the whole procedure from the beginning. Repeat the whole procedure if you want to
enter a new code number.

Nice FLOX2R Specifications

General

Frequency	433.92 MHz
Number of Channels	2
Power Supply	Battery
Modulation	ASK
Operating Temperature	-20°C to +55°C

Summary

INTRODUCTION

Rolling Code Security

Explains the Rolling Code technique for enhanced radio control security.

INSTALLATION

Channel Selection on Transmitter

Receivers with Terminals

Wiring and Connections

Provides instructions for wiring power, aerial, and relay outputs to terminal receivers.

Plug-in Receivers

Unit Connections and Signals

Memory Card Functionality

Disabling Function Types

Details hardware, software, and password-based methods for disabling system functions.

Adjustments and Settings

Relay Channel Selection

Explains how to use jumpers to assign receiver relays to specific transmitter channels.

Output Contact Configuration

Normally Open/Closed Configuration

Special Functions

Relay Output Modes

Describes step-by-step, timer, and anti-theft functions for relay outputs.

Installing the Aerial

Aerial Placement and Connection

Provides guidance on optimal aerial placement, cable use, and connection for reception.

Programming Procedures

LED Status Codes

Normal Code Entry Method

Remote Code Entry Method

Code Number Management

Deleting Single Code Numbers

Deleting All Code Numbers

Activating 2nd Learning Disabling

Programming Timer Time

Setting Timer Duration

Explains how to program the duration for the timer function via transmitter and receiver interaction.