ACTIVATING THE 2
ND
LEARNING DISABLING FUNCTION
1) Press the key on the receiver for a moment
2) Wait for the 2 flashes that indicate time end (about 5 seconds)
3) Press the key during the 2
nd
flash and release it as soon as the LED turns off.
2 flashes follow: the 2
nd
should last longer than the first to indicate that the disabling function is active;
if this does not happen, repeat the procedure from the beginning.
REMOVING THE 2
ND
LEARNING DISABLING FUNCTION
To remove the learning disabling function you will need an authorised remote control.
1) Press the receiver key for a moment, the LED turns on for 5 seconds within which time you have to:
2) Transmit the code until the LEDs turn off pressing any key on the transmitter.
3) Release the key on the transmitter and wait 1 second.
4) Transmit the code to confirm pressing any key on the transmitter; the LED will now flash 4 times
meaning that the code is already on the list.
5) Press the key during the 4th flash and let it go as soon as the LED turns off.
Two identical flashes will follow meaning that the disabling state is not active; if this does not
happen, repeat the procedure from the beginning.
To Next Page
Loading...
Need help?
General
