Nice Infinity Shock G2 - Page 52

_ENGLISH
52
S
S
The example below
shows the connection of
a sensor to zone 1.
In order to connect more than one
sensor to a same zone, follow the
example. Follow the same logic to
increase the number of sensors.
Note that the “alarm” contacts
should be connected in series. In
this case, any sensor that is violated
will trigger zone 1 of the central.
The example below
shows the connection of
two sensors to zone 1.
ATTENTION:
In order to enable the zone with the wire,
remove the jumper corresponding to the zone
(JZ jumper).
EN