ENGLISH_
55
EN
- Exclusive industrial-use electrier, not conceived for residential use.
- Before accessing the terminals, all supply circuits should be turned off.
- Read and follow all instructions in this manual before installing and/or
using this equipment.
- Never install the electrier, cables or electried fence in locations where
there are particularly hazardous conditions, e.g. in the presence of
corrosive agents, explosive atmosphere (with the presence of gases),
ammable liquids, etc.
- The xed wiring for the 127 - 220 Vac supply of the equipment should
have a safety switch or a similar device, such as a breaker. Such device
should enable a power grid shutdown without the need to open the
equipment’s cabinet, in addition to protecting the installation against
eventual short-circuits in the supply input.
S
Anode
Cathode
1k resistor
Electrifier connectors
ADDITIONAL INFORMATION
15
ATTENTION:
In the above example the LED will indicate
when the electrier is armed.
To Next Page
Loading...