_ENGLISH
56
- This equipment should be attached to a rigid wall or similar
construction, in vertical position, in a way that the user cannot
change its positioning without the assistance of tools. Do not
install the central on wooden surfaces or materials that favor
ame propagation in case of a wiring or equipment short.
EN
- Use only 12-volt rechargeable batteries, preferably the gel-seal type,
with 12 Vdc / 7 Ah and with a uctuation voltage (“stand-by use”) of 13.5
~ 13.8 Vdc.
- This equipment should never be opened, programmed or handled by
the end user. Whenever there is need for repair, reseting or installation, a
specialized technician should be hired.
- Installation and securing procedure for cables and accessories,
minimum fence height and distance between the warning signs are
Genno’s recommendations, based on our market experience as a
manufacturer. These guidelines should be followed whenever possible. If
there are any local laws that regulate this type of installation, they should
be fully observed.
- Follow the recommendations of this manual in regard to the installation
procedures and materials to be used while installing.
- In the case of a defect or malfunction, contact our support department.
- Inform the system user about the functioning and the risk level of the
electried fence and the precautions he should have while handling it.
- Request the user to allow the installing company, whenever they
deem necessary, to access their equipment and the components of the
electried fence for periodical technical revisions.
To Next Page
Loading...