Nice MC200 Instructions And Warnings For Installation And Use

15 – English
EN
PROCEDURE C - Memorising a transmitter by means of another transmitter already memorised (memorisation far
from the control unit)
This procedure allows for memorising a new transmitter by means of a second transmitter already memorised in the same control unit. This
enables the new transmitter to receive the same settings as the transmitter already memorised. The procedure does not entail any direct action
NMATSSNM3NESGDBNMSQNKTMHSATSHSRLDQDDWDBTSHNMVHSGHMHSRQDBDOSHNMQ@MFD
01. On the transmitter to be memorisedOQDRR@MCGNKCSGDATSSNMSNADLDLNQHRDC
02.
On the control unit@ESDQ@EDVRDBNMCRQNTFGKXSGDqUDGLRr/(' lights up. Release the transmitter key.
03.
On the transmitter already memorisedOQDRR@MCQDKD@RD3 times the memorised button to be copied.
04.
On the transmitter to be memorisedOQDRR@MCQDKD@RDonce the same button pressed at Step 01.
PROCEDURE D - Deleting a single transmitter (if memorised in Mode 1) or a single transmitter key (if memorised in
Mode 2)
01. On the control unitOQDRR@MCGNKCbutton T2.
– After roughly 4 seconds the qUDGLRr/(' lights up steady (continue holding the button down).
02.
On the transmitter to be deleted from the memoryOQDRR@MCGNKC@ATSSNM(*) until the qUDGLRr/('NMSGDBNMSQNKTMHSDLHSRE@RS
k@RGDRNQk@RGHESGDSQ@MRLHSSDQNQATSSNMHRMNSLDLNQHRDC
(*) Note - If the transmitter is memorised in Mode 1, any button can be pressed and the control unit deletes the entire transmitter. If the trans-
mitter is memorised in Mode 2, it is necessary to press the memorised button that must be deleted. To delete additional buttons memorised
in Mode 2, repeat the entire procedure for each button that must be deleted.
PROCEDURE E - Deleting ALL memorised transmitters
01. On the control unitOQDRR@MCGNKCSGDqUDGLRrEXWWRQ.
– After roughly 4 seconds the qUDGLRr/(' lights up steady (continue holding the button down).
– After roughly 4 seconds the qUDGLRr/(' turns off (continue holding the button down).
02.
When the qUDGLRr/('RS@QSRk@RGHMFBNTMSk@RGDRand prepare to release the button precisely during the 3
rd
ƅDVK that follows.
03. After the deletion, the qUDGLRr/('k@RGDRE@RS
04. Lastly, the qUDGLRr/('DLHSRKNMFk@RGDRSNRHFM@KSG@SSGDCDKDSHNMG@RADDMRTBBDRRETK

Nice MC200 Specifications

General

Brand	Nice
Model	MC200
Category	Control Unit
Language	English