2222
support.hysecurity.com
MERCURY 310 Controller
User Guide
7.1 Apollo 816 Actuator
7. MANUAL OPERATION
HITCH PIN
ACTUATOR
ARM
Apollo 816
Linear Actuator
R-CLIP
GATE
BRACKET
1. Pull the R-Clip from the hole in the hitch pin (See illustration below).
2. Pull the hitch pin from the gate bracket and actuator arm.
3. Swing the actuator assembly entirely out of the way and the gate can now be moved by
hand.
4. Reverse the procedure to re-ax the actuator to the gate.
Manual Release Instructions: Apollo 816 Linear Actuator
2
1
NOTICE
This procedure will only
work if the gate has been
installed using the hitch pin
and R-clip.
Contact your gate installer to
disconnect or replace other
hardware congurations.
To manually open the gate in the event of a full power outage, follow the instructions in this section
according to the type of actuator in your kit.
To Next Page
Loading...
Need help?
General
