18
1. Press key ■ repeatedly until the text Auto starts flashing
2. Press key three times to select programming mode Prog
▼
3. Press key to confirm programming mode
▼
4. Press key twice to select settings of parameters in the command “holiday”
▼
5.4) Settings of special command "holiday" parameters
To ensure correct operation of the special command “holiday” the maximum admissible deviation value must be set; this
can be from 0 to 75 minutes, settable at intervals of 5 minutes. For example, if the value 15 is set, this means that an
event programmed for 08.00 can be performed randomly between 7.45 and 8.15.
The modification of this parameter affects all the events with this special parameter enabled.
... Auto
7. Press key to confirm the parameter
▼
5. Press key to confirm settings of parameter “holiday”
“”
▼
6. Press key or to set the maximum deviation in minutes
▼
▼
or
1. Press key ■ repeatedly until the text Auto starts flashing
3. Press key to confirm programming mode
▼
4. Press key three times to select settings of the parameters in the special
command “planetary time”
▼
5.5) Settings of special command "planetary time" parameters
To ensure correct operation of the special command “planetary time” the following parameters need to be set:
• Latitude of location with respect to the earth's equator, settable between 65° (towards North pole) and
-65°
(towards South pole) passing through 0° (equator).
To find the “ ” value to be entered, refer to the figure on the next page or a geographical map for a more pre-
cise location
• Difference between the time shown on the timer and the actual solar time; in practice the difference between mid-
day shown on the clock and the midday of the real solar time of the location “ ” can be set between 0 and ±99
minutes. The chapter “how to…” specifies a procedure to measure this value.
If a precise setting is not necessary, this parameter can be set to zero.
• Indication of whether the time is winter (solar time) or summer (legal time).
... Auto
11. Press key to confirm the parameter
▼
These parameters should not be changed after entering one or more events with this special command enabled.
5. Press key to confirm settings of parameters in the command “planetary time”
▼
7. Press key to confirm the parameter
▼
9. Press key to confirm the parameter
▼
10. Press keys or to select summer time “S” (legal time) or winter time “W”
(solar time)
▼
▼
or
6. Press key or to set the location latitude “ ”
▼
▼
or
8. Press key or to set the difference between the time shown on the clock
and the actual solar time “ ”
▼
▼
or
2. Press key three times to select programming mode Prog
▼
Table 29
Setting parameters of special command “holiday”
Example
Table 30
Setting the parameters of the special command “planetary time”
Example
To Next Page
Loading...
Need help?
General
