What to do if Nidec DC Drives show drive overload?
If your Nidec DC Drives are showing a drive overload, first check the input power source for low voltage. If the load is too heavy, select a drive with a bigger capacity. If the acceleration is too fast, increase the acceleration time. Also, avoid restarting the motor while it's still turning.
What causes over current at constant-speed in Nidec DC Drives?
If you're experiencing overcurrent at a constant speed with your Nidec DC Drives, several factors could be the cause. Check the load for any abnormal mutations. Also, verify the input power source isn't experiencing low voltage. Ensure your drive has sufficient power capacity. Finally, if you're using closed-loop vector control, inspect the encoder and its wiring for any sudden disconnections.
What causes over current in Nidec NE300-4T2000G/2200P-U during acceleration and how to fix it?
Overcurrent during acceleration in Nidec DC Drives can stem from a few reasons. If the acceleration time is too short, increase it. Also, check the input power source for low voltage. Finally, if the drive power rating is too small, choose a drive with higher capacity.
Provides detailed technical specifications for NE200 and NE300 drives.
Illustrates the connection of the drive with peripheral devices.
Shows terminal configurations for the main circuit of different drive models.
Highlights important considerations for main circuit wiring.
Details wiring diagrams for control terminals of NE200 and NE300.
Describes the keypad types, model names, and diagrams.
Explains the three-level menu structure for parameter setting.
Lists and describes basic function parameters (F0).
Details parameters related to start and stop control (F1).
Lists and explains vector control parameters (F3).
Details V/F control parameters (F4).
Explains parameters related to motor characteristics (F5).
Lists and explains PID control parameters (F8).
Lists parameters for protection and fault handling (FC).
Details communication parameters (Fd).
Describes basic function parameters (F0).
Details start and stop control parameters (F1).
Lists and explains vector control parameters (F3).
Details V/F control parameters (F4).
Explains parameters related to motor characteristics (F5).
Lists parameters for protection and fault handling (FC).
Lists faults, possible causes, and solutions.
To Next Page
General