Need help?Do you have a question about the Nidek Medical AR-360A and is the answer not in the manual?
General| Type | Auto Ref/Keratometer |
|---|---|
| Axis | 1° to 180° |
| Pupil Diameter Measurement Range | 2.0 to 8.0 mm |
| Minimum Pupil Diameter | 2.0 mm |
| Printer | Built-in thermal printer |
| Power Requirements | AC 100-240 V, 50/60 Hz |
| Display | LCD |
Details device classifications for electrical shock protection and water ingress.
Lists detailed technical specifications for refractive error and other measurements.
Guides users through troubleshooting specific error codes displayed by the device.
Outlines procedures for diagnosing and fixing measurement failures.
Guides users on how to access the adjustment modes via the MENU.
Procedures for adjusting the chart alignment and position.
Steps for performing the alignment calibration procedure.
Detailed procedure for calibrating the AR measurement function.
Instructions for calibrating the KM measurement function.
Steps for calibrating the PD measurement.
Procedure for calibrating CS/PS measurements.
Guide for automatically adjusting the tracking function.
Instructions on how to perform software upgrades using a USB drive.
Instructions for rewriting EEPROM data, typically after board replacement.
Lists all possible error codes, their contents, and detailed explanations.
To Next Page