Need help?Do you have a question about the Nidek Medical YC-1800 and is the answer not in the manual?
General| Laser Source | Nd:YAG |
|---|---|
| Wavelength | 1064 nm |
| Pulse Duration | 4 ns |
| Type | YAG Laser |
| Energy | 0.3 to 10 mJ |
| Burst Mode | 1, 2, or 3 pulses |
| Aiming Beam | 635 nm red diode laser |
| Power Supply | AC 100 to 240 V, 50/60 Hz |
| Magnification | 10x |
General safety and servicing guidelines for the YC-1800.
Precautions and procedures to follow during maintenance operations.
Safety precautions specific to laser beam emission.
Guidelines for safely handling and returning the laser head for repair.
Precautions and guidelines for adjusting the YC-1800 system.
Instructions for using the energy meter with the YAG laser system.
Troubleshooting steps for when the pilot lamp fails to illuminate.
Diagnostic steps for fixation or backlight panel lamp failures.
General troubleshooting for error messages displayed on the system.
Resolving problems with the illumination light projection.
Adjusting microscope optical axis when PD changes cause rod movement.
Diagnosing and fixing smooth movement issues with the base.
Troubleshooting steps for when the aiming beam fails to emit.
Steps to take when the READY indicator is not illuminated.
Resolving abnormal YAG laser energy output measurements.
Troubleshooting the emergency stop switch functionality.
Instructions for removing the right and left external covers.
Steps to remove the base cover A.
Procedure for removing the lower cover.
Steps to remove the vertical movement cover.
Detailed steps for removing base cover C and related components.
Instructions for removing the arm covers from the system.
Procedures for replacing various circuit boards.
Instructions for replacing different cable assemblies.
Procedure for replacing the display panel assembly.
Steps for replacing the microscope unit.
Steps for replacing the lamp house.
Procedure for replacing the MYLA laser head.
Procedure for replacing the racks.
Procedures for aligning the microscope's optical axis.
Steps to adjust the illumination rotation center for proper alignment.
Procedures for adjusting the aiming spots for accuracy.
Procedures for aligning the YAG laser optical axis.
Detailed steps for adjusting the focus of the YAG laser beam.
Procedures for performing electrical adjustments on the system.
Performing the initial setup and configuration of the master board.
Adjusting the power output of the aiming beam.
Adjusting and verifying the PFN voltage settings.
Procedures for measuring and setting YAG laser beam energy output.
Steps to achieve the minimum YAG laser beam energy output.
Procedures for displaying and setting energy output values.
Performing checks on the YAG laser beam energy output.
Steps for setting various system parameters.
Adjusting the vertical movement base for smooth operation.
Adjusting parameters related to the smart switch function.
Electrical wiring schematic of the system.
Details of connector cables and their pin assignments.
Table listing error codes, symptoms, and causes.
Table detailing the function of dip switch settings.
Tables defining system parameters and their settings.
To Next Page