12
En
Fr
■
Changing the distance display unit
(m/YD)
Factory default setting is yard (YD).
1. Turn on the power (Confirm the internal display is on).
2. Press and hold the MODE button for more than 2 seconds.
When the display unit has been switched, release the button.
■ Changing the target priority mode
This Nikon Laser Rangender employs the First Target Priority/Distant Target Priority switching system.
(Factory default setting is First Target Priority mode).
1.Turn on the power (Conrm the internal display is on)
2. Press and hold the MODE button, then depress and hold the PWR button within 0.5 second.
Continue to press and hold both button (more than 2 seconds) until First Target Priority mode and
Distant Target Priority mode are switched.
3. Release both buttons when the mode is switched.
*If the buttons are not pressed in the correct order, switching will not take place.
[First Target Priority mode/Distant Target Priority mode]
When measuring overlapping subjects:
First Target Priority mode displays the distance of the closest subject and
Distant Target Priority mode displays that of the farthest subject.
[Mode settings]
To Next Page
Loading...
Need help?
General
