HTTP://WWW.SHORTCOURSES.COM
5
THE SHORT COURSES WEB SITE AND ON-LINE DIGITAL PHOTOGRAPHY BOOKSTORE
A SHORT COURSE IN NIKON COOLPIX 5000 PHOTOGRAPHY
2. Use any of the procedures described in the
QuickSteps box “Managing Your Images.”
3. To resume shooting, slide the mode selector to
shooting mode (the camera icon).
Managing Your Images
■■
■■
■ To display one image after another, press the
up or left point on the Multi Selector to scroll
backward through the images or the right or
down point to scroll forward.
■■
■■
■ To scroll quickly through the images, hold
down a point on the Multi Selector as you watch
the image numbers on the monitor change
(although the image won’t change until you
release the point).
■■
■■
■ The first and last images are linked so you can
scroll from one to the other in either direction.
■■
■■
■ To zoom the displayed image up to 6x, press or
hold down the zoom-in (T) button. The amount of
zoom is displayed in the upper left corner of the
monitor. To scroll around the zoomed image press
the points on the Multi Selector. To cancel zoom,
press the zoom-out (W) button.
■■
■■
■ To delete the displayed image, press the AF/
MF button with the trash can icon above it. When
prompted to confirm the deletion, press the up or
down point on the Multi Selector to highlight Yes,
then press the right point to delete the image.
■■
■■
■ To turn the information display on or off,
press the MONITOR button as many times as
necessary (page 12).
■■
■■
■ To scroll through up to five pages of informa-
tion about the displayed image and camera
settings (including the firmware version), rotate
the Command Dial. One page shows a histogram
illustrating the levels of luminance in the image
(page 53). If you can only see the histogram screen
no matter how much you rotate the Command
Dial, press the MONITOR button twice to turn the
monitor’s information display on.
■■
■■
■ To play a movie see page 21.
Managing Images You Just Shot
■■
■■
■ To delete an image as it’s being saved and
displayed on the monitor, press the AF/MF
button. A prompt appears with the choices Yes or
No. Highlight one and press the right point on the
Multi Selector to select it.
■■
■■
■ To pause the display for 20 seconds or cancel a
pause, press the Flash/ISO button and REC is
displayed. While paused, you can press the same
button to resume shooting or the AF/MF button
to delete the image. To return to shooting mode,
press the shutter button halfway down and then
release it, or press it all the way down to take a
picture.
Using Quick Review
■■
■■
■ To display the last image you took so it fills
one-quarter of the monitor, press the QUICK
button above or below the monitor.
■■
■■
■ To enlarge the one-quarter view image to full-
screen, push the QUICK button a second time.
■■
■■
■ To view other photos when an image is dis-
played one-quarter or full-screen, press the left or
right point on the Multi Selector.
■■
■■
■ To return to shooting, press the shutter button
halfway down, or press QUICK when the image is
displayed full screen.
Using Thumbnail Playback
1. With the camera on and the monitor open,
slide the mode selector to Playback (the
arrowhead in a box icon) or press the Quick
button twice to display images full-screen.
2. Press the zoom-out (W) button once to display
4 images, twice to display 9, and three times to
return to the normal view.
3. Use any of the following commands when
viewing thumbnails:
■■
■■
■ To move the yellow selection frame from
one image to another, press the points on the
Multi Selector.
■■
■■
■ To move forward or back a page at a time,
rotate the Command Dial.
■■
■■
■ To zoom the selected thumbnail to fill the
screen, press the zoom-in (T) button twice if
viewing nine thumbnails, or once if viewing
four.
■■
■■
■ To delete the selected image, press the AF/
MF button with the trash can icon above it.
When prompted to confirm the deletion, press
the down point on the Multi Selector to high-
light Yes, then press the right point to delete the
image.
Playing Movies
1. With the camera on and the monitor open,
slide the mode selector to Playback (the
arrowhead in a box icon).
2. Scroll to a movie indicated by a display of its
first frame and marked with a movie icon and
press the QUAL/SIZE button once to load the
movie and again to play it.
3. Use any of the following commands when
viewing movies:
To Next Page
Loading...
Need help?
General
