Nikon COOLPIX P520 - Connecting the Camera to a Printer (Direct Print); Connecting the Camera to a Printer

E19
Reference Section
Connecting the Camera to a Printer (Direct Print)
Users of PictBridge-compatible (F22) printers can connect the camera directly to
the printer and print pictures without using a computer.
Connecting the Camera to a Printer
1 Turn off the camera.
2 Turn on the printer.
• Check the printer settings.
3 Connect the camera to the printer using the included USB cable.
• Be sure that the plug is oriented correctly. When disconnecting the cable, do not pull
the plug at an angle.
4 The camera is automatically turned on.
• When connected correctly, the PictBridge startup screen (1) is displayed on the
monitor screen of the camera. Then the Print selection screen (2) is displayed.
B If the PictBridge Startup Screen Is Not Displayed
Turn the camera off and disconnect the USB cable. Set the Charge by computer option (E76) in
the camera’s setup menu to Off and reconnect the cable.
B Notes on Power Source
• When connecting the camera to a printer, use a fully charged battery to prevent the camera from
turning off unexpectedly.
•
If the AC Adapter EH-62A (available separately) ( E 92) is used, the COOLPIX P520 can be powered
from an electrical outlet. Do not, under any circumstances, use an AC adapter other than the EH-62A.
Failure to observe this precaution could result in overheating or damage to the camera.
32
32
NO.
2013
15/05
Print selection