10
First Steps
First Steps
Inserting the Battery
The camera uses a rechargeable EN-EL8 Li-ion battery (supplied).
1
Turn the camera off
If the power-on lamp is lit, press the power switch
to turn the camera off .
2
Open the battery-chamber/memory card slot
cover
3
Insert the battery
The orange battery latch is pushed aside as the
battery is inserted. The battery is fully inserted
when the latch clicks back into place.
Inserting the Battery
Inserting the battery upside down or backwards could
damage the camera. Check to be sure the battery is in
the correct orientation.
4
Close the battery-chamber/memory card slot
cover
Batteries
Read and follow the warnings and cautions on pages ii–iii and 92 of this manual.
Removing the Battery
Turn the camera off before removing or inserting batteries. To
eject the battery, open the battery-chamber/memory card
slot cover and slide the battery latch in the direction shown.
The battery can then be removed by hand. Note that the bat-
tery may become hot during use; observe due caution when
removing the battery.
To Next Page
Loading...
