VAA46003-R.3659.A
- R1･ E7900 -
Item Criteria Applied tool(s)
External view
Gap/Difference in
height
Outside and inside
status
・ General components
Gap: 0.3mm or less
Difference in height: 0.15mm or less
・ Clearance between the battery case and the back surface of the
rear cover: 0.5mm or less : 0.3mm or less when there is a bulge.
・ Clearance between the SD card cover, the belt and the rear cover:
Total clearance of the up-and-down direction: 0.45mm or less
Play in the up-and-down direction: 0.2mm or less
・ There must be no noticeable damage, soil, sink mark, welded
mark, crack or oil exudation.
Visual observation
Visual observation
Operation/Operability
Operation
Operability of buttons
Mode/Dial
・ While operating, any irregularities or irregular noise shall not be
required.
(Check it by shaking the camera while operating.)
(Lightly hit the camera onto the Linoleum-laid desk while
operating.)
・ No cave-ins of the buttons shall be required.
・ Operator must feel "click" on each button.
・ "Click" must occur when or after a switch is ON.
・ Buttons must be pressed by the belly of your finger.
(Check it while operating normally.)
・ When clicking, normal touch shall be required. Any outstanding
"caught-in-mechanism" touch or "rubbed-in-mechanism" touch or
play shall not be required.
(Check and observe the condition through normal operation.)
Primary battery/
Secondary battery
INSPECTION STANDARDS
To Next Page
Loading...
