Nikon D3 - Page 414

388
n
Remote
terminal
accessories
The D3 is equipped with a ten-pin
remote terminal for remote control
and automatic photography. The
terminal is provided with a cap, which
protects the contacts when the
terminal is not in use.
The following
accessories can be used (all lengths are approximate):
Accessory
Description Length
Remote Cord
MC-22
Remote shutter release with blue, yellow,
and black terminals for connection to a
remote shutter-triggering device, allowing
control via sound or electronic signals.
1m
(3 ft. 3 in.)
Remote Cord
MC-30
Remote shutter release; can be used to
reduce camera shake or keep the shutter
open during a time exposure.
80 cm
(2 ft. 7 in.)
Remote Cord
MC-36
Remote shutter release; can be used for
interval timer photography or to reduce
camera shake or keep the shutter open
during a time exposure.
Equipped with
back-lit control panel, shutter-release lock
for use in bulb photography, and timer that
beeps at one-second intervals.
85 cm
(2 ft. 9 in.)
Extension Cord
MC-21
Can be connected to ML-3 or MC-series 20,
22, 23, 25, 30, or 36.
Only one MC-21 can
be used at a time.
3m
(9 ft. 10 in.)
Connecting Cord
MC-23
Connects two cameras for simultaneous
operation.
40 cm
(1 ft. 4 in.)
Adapter Cord
MC-25
Ten-pin to two-pin adapter cord for
connection to devices with two-pin
terminals, including the MW-2 radio
control set, MT-2 intervalometer, and ML-2
modulite control set.
20 cm
(8 in.)
GPS Adapter Cord
MC-35
Connects GPS devices to D3 via PC cable
supplied by manufacturer of GPS device
(pg. 223).
35 cm
(14 in.)
Modulite Remote
Control Set ML-3
Allows infrared remote control at ranges of
up to 8 m (26 in.).
—