Nikon D3X - Connecting to a Computer

256
Q
Connecting to a Computer
This section describes how to connect the camera to a computer
using the supplied UC-E4 USB cable.
Once the camera is
connected, Nikon Transfer (supplied) or optional Nikon software
such as Camera Control Pro 2 can be used to copy photographs to
the computer or control the camera remotely.
D Connecting Cables
Be sure the camera is off when connecting or disconnecting interface
cables.
Do not use force or attempt to insert the connectors at an angle.
A Camera Control Pro 2
Camera Control Pro 2 (available separately; pg. 391) can be used to control
the camera from a computer.
Before connecting the camera, set the
camera [USB] option (pg. 257) to [MTP/PTP]. When Camera Control Pro 2
is running, “c” will be displayed in the top control panel.