373Technical Notes
❚❚ Supplied Accessories
• LC-55A 55 mm Snap-on Front Lens Cap
• Rear Lens Cap
❚❚ Compatible Accessories
• 55 mm screw-on filters
• LF-4 Rear Lens Cap
• CL-0815 Lens Case
• HB-N106 Bayonet Hood
Align the lens hood mounting mark (●) with the lens hood
alignment mark ( ) as shown in Figure q and then rotate
the hood (w) until the ● mark is aligned with the lens hood
lock mark (—).
When attaching or removing the hood, hold it near the symbol
on its base and avoid gripping it too tightly. Vignetting may
occur if the hood is not correctly attached. The hood can be
reversed and mounted on the lens when not in use.
To Next Page