[2]
Check
pOints
z
o
fi
o
To
change film speed with DX-coded film or select film advance mode,
a:
see pages 36-37.
~
o Shutter curtains
are
very thin.
Do
not touch the shutter curtains with 0
o
your finger or the film
leader.
ii5
o Avoid direct sunlight when changing film outdoors. :i
3.3
3.4
Hold the film cartridge and ensure film
is
properly
positioned with no slack, then gently close the
camera back until the camera back snaps closed.
Film automatically advances to the first frame.
x
•
When
: appears
on
the
LCD
panel, the film
has
advanced to the first frame.
• When
Err and E blink
in
the LCD panel and viewfinder, film
is
not
properly installed. Open the camera back again and reload film.
•
Ii}J
and Err
in
the LCD panel and Err
in
viewfinder blink and the shutter
locks when a non-OX-coded film
is
loaded with camera film speed set to
1i}J
. Set film speed manually (page
36)
.
• Frame number display remains when the power switch
is
off.
•
You
can check the number of available exposures
on
the film roll through
the film cartridge confirmation window.
• Infrared films cannot be used since
an
infrared sensor
is
used for the
detection of the film frame position.
~
B:
Camera can be set to advance the film to the first frame not until
the shutter release button
is
pressed (page
72)
.
Set the film advance mode selector to []] (single-
frame shooting) while pressing the film advance
mode selector lock release.
21
To Next Page
Loading...
Need help?
General
