Flash
Photo
• Built-in Speedlight
This camera
is
equipped with a built-in Speed light that provides
an
angle of
coverage for a 28mm lens with a guide number of
12
(IS0100,
m)
or 40
(IS0100, ft.).
TIL
Auto Flash modes such
as
3D
Mult
i
-Sensor
Balanced Fill-
Flash and
Multi-Sensor
Balanced Fill-Flash are available and ensure proper
exposure
of
the main subject and background, while providing adequate flash
output to create natural-looking flash photography.
In
addition to shooting
in
dim
light, the flash can be used
in
daylight to reduce shadows
on
the main subject
or to put catchlights in your subject's eyes. Five flash sync
modes-Front-
Curtain Sync (Normal Sync), Slow Sync, Rear-Curtain Sync, Red-Eye Reduction
and Red-Eye Reduction with Slow
Sync-are
available with this camera.
• See below for the
TIL
Flash modes, page
82
for using the built-in Speedlight,
page 80 for the flash sync modes and page
86
for the optional Speedlights .
• The following
TIL
Auto Flash modes
are
available with built-in
Speedlight depending
on
the type of lens used.
See
page 86 for the
optional Speedlights.
78
Lens
TIL
Auto Flash
mode
0- or G-type Nikkor lens
3D Multi-Sensor Balanced Fill-Flash*'
(with
Distance Information
and
Monitor
Pre-Flash
*
2)
CPU
Nikkor
lens
other
than
D/
G-
Multi-Sensor Balanced Fill-Flash*'
type
(
except
AF
Nikkor
for
F3AF)
(with Monitor
Pre
-Flash
*2
)
Non-CPU Nikkor lens Standard
TIL
*3
", When built-in Speed/ight is used
and
the exposure mode is set to Manual
or
Spot metering
is selected,
TTL
Auto Flash mode automatically changes to Standard
TTL
Flash.
"2
To
cancel Monitor Pre-Flash, select Manual exposure
mode
or
Spot
metering.
"3 Monitor-Pre Flash
is
not
fired in Standard
TTL
Flash.
3D Multi-Sensor Balanced Fill-Flash
3D
Multi-Sensor Balanced Fill-Flash can be performed with a combination of the
N80/N80aD camera and 0-
or
G-type Nikkor lens.
In
this flash mode, just after
you press the shutter release button and before the shutter
is
activated, the
built-in Speed light will fire a series of imperceptible pre-flashes that
are
detected
by the N80/N80aD's five-segment
TIL
Multi Sensor, then analyzed for
brightness and contrast. Furthermore, it integrates Distance Information from the
lens with other exposure control information, automatically compensating the
fl
ash
output level so that flash output and ambient
li
ght
are
balanced.
3D
Multi-Sensor Balanced Fill-Flash enables flash photography
in
very difficult
situations, such as a scene that includes
an
object with extremely high reflectivity
or a subject against
an
"infinite" background (empty
sky,
clouds, etc.) .
• Set the camera's exposure mode to any mode other than Manual and
metering system to other than Spot when using built-in Speedlight.
To Next Page
Loading...
Need help?
General
