• If fi
lm
does not start to rewind or film rewind stops at mid-roll
• When battery power is ve
ry
low,
or
at low temperatu
re
s, film may not start
rewinding or film rewind may stop at mid-roll, and
0
__
and frame number will
blink in the LCD panel.
In
this case, turn the power switch off, change
batteries, then turn the power switch on and rewind
fi
lm again .
• Film advance mode
Rotate the f
il
m advance mode selector wh
il
e press
in
g
the film advance mode selector lock release to select
film advance mode .
• The following film advance modes are available:
i]]:
Single-frame shooting
Fully depressing the shutter release button takes one picture and
automatically advances the film by one frame.
~
:
Continuous shoo
ti
ng
Shots are taken continuously at the rate
of
up to appro
x.
2.5 fps
as
long
as
you keep the shutter release button fully depressed.
Film ad
va
nce speed is tested using camera
se
ttings of focus mode M, exposure
mode M, shutter speed
1/125 sec. or faster, aperture other than maximum, at
normal temperature of 20°C (58°
F)
, with fr
es
h batte
ri
es, for the 1 st to 35th f
ra
m
es
of a film.
• When the film advance mode selector
is
set to
~
,
multiple exposure can be
performed (page
63)
. Also, when it is set to 0 , self-timer operation can be
performed (page
68)
.
37
To Next Page
Loading...
Need help?
General
