EasyManuals Logo

Nikon N80QD - F80 QD Quartz Databack User Manual

Nikon N80QD - F80 QD Quartz Databack
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #87 background imageLoading...
Page #87 background image
Notes on using the optional Speed light
See
your Speed light manual for details. If the came
ra
groups
are
defined
in
the
manual of the Speed light with
TIL
auto flash,
see
the section for camera group
I.
Flash sync speed is
1/
125 sec. or slower when using
an
optional Speedligh
t.
Available film speeds for
TIL
auto flash are ISO 25 to ISO 1000.
With the SB-26,
25
or
24
, flash sync mode set on the Speed light overrides the
setting
on
the camera body.
When Red-Eye Reduction or Red-Eye Reduction with Slow Sync
is
set
on
a
camera attached with the SB-80DX,
28
/28DX,
27
or
26
, the Red-Eye
Reduction lamp of the Speedlight
li
ghts up.
Even
when the optional Speedlight with the AF-Assist Illuminator is attached,
AF
-Assist Illuminator does not emit light unless the conditions for
AF
-Assist
Illumination are met (page
43)
.
With SK-6 and SB-24 are attached, AF-Assist Illuminators of the camera body
and the Speed light do not emit light.
In
Auto-Multi Program, the camera automatically controls the maximum
available aperture
as
follows
in
relation to the film speed:
ISO film speed
25 50 100 200
400
800 1000
Maximum
I Built-in Speedlight 2 2.4 2.8 3.3 4 4.8
-
available I
aperture Optional Speedlight
2.8 3.3 4 4.8 5.6 6.7 6.7
When film speed Increases by one step, the maximum available aperture
IS
stopped down by
1/2
f/stop. If you are using a lens with a maximum aperture
smaller than that listed above, the automatically controlled aperture range
is
from the lens' maximum to minimum aperture.
Use the optional Accessory Shoe Adaptor AS-15 to use the sync terminal
When flash exposure compensation
is
set,
~
appears
in
the viewfinder
without the compensation value.
FE
E
in
the LCD panel and P
in
the viewfinder blink and the shutter cannot be
released when the exposure mode
is
set to P and attached SpeedJight
is
not
set to
TIL
Auto Flash. Set the SpeedJight flash mode
to
TIL
, or set the
camera's exposure mode to S, A or M.
To
cancel Monitor Pre-Flash when using the SB-80DX, 50DX,
28/28DX
,
27
, 26
or
25
, select Spot metering.
Using camera's built-in Speedlight and the SB-50DX, double-flash operation
and bounce-flash operation with double flash can be performed.
NOTE
: Fl
ash
attachments
made
by
manufacturers
other
than
Nikon
Use only Nikon Speedlights. Other units may damage the camera's electrical
circuit due
to
incompatible voltage requirements (not compatible with 250V
or higher), electric contact alignment or switch phase. .
87

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nikon N80QD - F80 QD Quartz Databack and is the answer not in the manual?

Nikon N80QD - F80 QD Quartz Databack Specifications

General IconGeneral
BrandNikon
ModelN80QD - F80 QD Quartz Databack
CategoryFilm Camera
LanguageEnglish

Related product manuals